How to Install a Yale Assure Lever Touchscreen Standalone

By Yale Locks | Official Online Store | Yale Home | Published: 2026-10-24

Category: How-to Guides

Step-by-step guide for installing the Yale Assure Lever Touchscreen standalone keypad lock. Covers preparation, wiring, and setup for keyless entry.

Quick answer

Installing the Yale Assure Lever Touchscreen Standalone takes about 30 minutes with basic tools. Follow these steps to replace an existing keyed lever or install on a new door.

Before you start: tools and door prep

You will need a Phillips screwdriver, a tape measure, and a pencil. The Yale Assure Lever Touchscreen is designed for standard keyed entry doors with a 2-1/8-inch bore hole and a 1-inch edge bore. Check your door thickness (1-3/8 to 1-3/4 inches) before beginning.

If you are replacing an existing lever, remove the old hardware completely. Keep the screws from the old lock—they may be needed if your door has non-standard prep.

Understanding the standalone configuration

This model is a standalone keypad lock, meaning it does not connect to Wi-Fi or a smart home hub out of the box. It uses the touchscreen keypad for entry and operates on 4 AA batteries (not included).

Because it is standalone, you will not need to run any network cables or configure an app for basic use. Programming is done directly on the keypad.

Installation steps

Remove the existing lever and prepare the door: Unscrew and remove the old lever and latch. Insert the new latch into the door edge with the bevel facing the door frame. Secure it with the two provided screws. Make sure the latch retracts smoothly when you turn the lever. Common mistake: Installing the latch upside down. The bevel should face the door frame so the latch retracts when the door closes.
Install the exterior lever assembly: Feed the cable from the exterior lever through the door bore hole. Align the lever with the latch and press it flush against the door. The touchscreen keypad should face outward. Checkpoint: Ensure the cable is not pinched between the lever and the door. A pinched cable can cause keypad failure.
Install the interior lever assembly: Connect the cable from the exterior lever to the interior assembly. Tuck excess cable into the door bore hole. Place the interior lever over the mounting studs and secure it with the provided screws. Attach the battery pack and insert 4 AA batteries. Common mistake: Not tucking the cable completely. Excess cable can prevent the interior lever from sitting flush.
Align the lever and test the latch: Turn the interior lever to ensure the latch retracts. If it feels stiff, loosen the mounting screws slightly and adjust the position of the interior assembly. Tighten once the lever moves smoothly. Checkpoint: The lever should return to its horizontal position after use. If it sags, the mounting screws may be too tight.
Program your entry code: Press the Yale button on the keypad, then enter the master code (default is 1-2-3-4). Follow the voice prompts to set a new master code and up to 20 user codes. Test each code by locking and unlocking the door. Common mistake: Forgetting to change the default master code. Change it immediately to prevent unauthorized access.

Product facts

Yale Assure Lever Touchscreen, Standalone: The Yale Assure Lever Touchscreen is a standalone keypad lever lock designed for keyed entry, available in Black Suede, Oil Rubbed Bronze, and Satin Nickel. Choose a finish that matches your existing door hardware for a cohesive look, and note that the standalone design means no Wi-Fi or hub is required for basic keyless entry.
Yale Assure Lever Touchscreen, Standalone