Yale Assure Lock Keypad: Features and Setup Guide
By Yale Locks | Official Online Store | Yale Home | Published: 2026-10-31
Category: How-to Guides
Learn how to set up the Yale Assure Lock Keypad, a key-free deadbolt that lets you lock and unlock with a simple code. This guide covers features, installation steps, and common mistakes to avoid.
Quick Answer
The Yale Assure Lock Keypad replaces your old deadbolt with a keypad that unlocks with a 4-8 digit code. Setup takes about 30 minutes with a screwdriver and a few simple steps.
What Makes the Assure Lock Keypad Different
Unlike smart locks that require a hub or Wi-Fi module for remote access, the Assure Lock Keypad works as a standalone keypad deadbolt. You unlock by entering a 4-8 digit code on the keypad, and you can lock the door behind you by pressing any key. This makes it a simple, reliable upgrade if you want to stop carrying keys without adding network complexity.
A common trade-off: because this model does not include built-in Wi-Fi or Z-Wave, you cannot control it from a phone app or voice assistant unless you add a separate module. For many homeowners, that is a fair exchange for a lower price and no batteries draining from constant wireless activity.
How to Set Up the Yale Assure Lock Keypad
- Remove the Old Deadbolt: Unscrew the interior plate of your existing deadbolt, disconnect any wiring, and pull out the latch assembly. Keep the screws and strike plate if you need them later. Common mistake: forgetting to check the door edge thickness. The Assure Lock Keypad fits doors 1-3/8" to 1-3/4" thick; measure yours before starting.
- Install the New Latch and Exterior Assembly: Insert the included latch into the door edge, then feed the cable from the exterior keypad through the cross-bore hole. Secure the exterior plate with the provided screws. Make sure the latch is oriented with the bevel facing the door jamb; a reversed latch will not align with the strike plate.
- Attach the Interior Mounting Plate: Slide the interior mounting plate over the cable and align it with the screw holes. Tighten the screws evenly so the plate sits flush against the door. Over-tightening can crack the interior plate; stop as soon as the plate is snug and does not wiggle.
- Connect the Cable and Install the Interior Assembly: Plug the cable from the exterior keypad into the connector on the interior assembly. Tuck the excess cable into the door cavity, then snap the interior assembly onto the mounting plate. If the cable is pinched or kinked, the connection may fail. Route it so it lies flat before snapping the cover closed.
- Insert Batteries and Program Your Code: Open the battery compartment on the interior assembly, insert four AA batteries (not included), and close the cover. Press the Yale button on the interior, enter a 4-8 digit master code, and confirm it. Common mistake: using a code that is too short or too similar to your old one. Choose a code that is at least 6 digits and does not include repeated or sequential numbers.
- Test the Lock and Adjust the Handing: Close the door and try locking and unlocking with the keypad. If the latch does not extend or retract smoothly, use the handing switch on the interior to change the rotation direction. A sticking latch usually means the strike plate needs slight adjustment or the handing setting is wrong. Test with the door open first to isolate the issue.
Product Facts
- Yale Assure Lock Keypad with: The Assure Lock Keypad deadbolt lets you unlock your home without keys by entering a 4-8 digit entry code on the keypad. You can set a code that is easy to remember but hard to guess, and you never have to worry about losing keys again.
Yale Assure Lock Keypad with - Yale Assure Lock Keypad with: Lock the door behind you by pressing any key on the keypad. This one-touch locking feature ensures you never forget to lock up after leaving, adding a simple habit to your daily routine.
